Baler manufacturers share what details should be paid attention to when installing tape from the box sealer

Now many factories have begun to introduce enclosure equipment, which can be completed in one go. The action of the lower sealing box can quickly paste the tape, which greatly meets our production requirements. When using a box sealer, it is very necessary to install tape. There are many details that need to be paid attention to in seemingly simple work, otherwise it will cause unnecessary failures. Below, the editor of the baler manufacturer will briefly introduce the details you need to pay attention to when installing tape using the box sealer.

Be careful when installing tape. Users who have used a box sealer know that when installing tape rolls, they need to pass the position of the box sealer blade. According to operating procedures, the tape head is cut with scissors, but many operators use the box sealer blade to cut the tape directly for convenience, but the operator may contact the blade and may get scratched if not careful.

When installing tape, the box sealer should pay attention to the following aspects:

The tape roll should be installed firmly.

The fixing of the tape roll of the box sealer is done by three clamp springs. The clamping force of these three clamping springs is very strong. During installation, the user must secure the tape roll to the machine or the tape may fall off during operation.

Try to avoid dust on the tape-bonded surface.

When the tape roll of the box sealer is installed for the first time, the installer's hand will accidentally touch the adhesive surface of the tape, reducing the viscosity of the tape and affecting the quality of the seal. Therefore, when installing tape rolls, try to avoid dust.

The tape surface should be installed smoothly.

After the tape is pulled out from the sealer, there may be some wrinkles. The sealing machine must be flattened before sealing, otherwise it will affect the sealing effect.

Adjust the knob of the tape holder.

Open the power switch of the tape sealer to make the machine work, and then push it into the carton to seal. If you find that the tightness of the upper and lower sealing tape is inconsistent, please adjust the knob of the tape holder. Generally speaking, if the tape is too tight, the spring pressure will relax; if the tape is too loose, the spring pressure will increase.

Adjust the blade on the tape head.

If the lengths of the two ends of the sealing tape are inconsistent, adjust the cutting blade in the sealing tape head. Generally speaking, the head is long and the tail is short. Adjust the cutting blade, loosen the locking screws of the cutting blade, move the cutting knife outward, and then lock the screws. Instead, if the head is short and the tail is long, move the cutting knife inward.

The sealing machine seals the carton with tape, which is economical and fast. Easy to adjust and can be done in one go. Automatic sealing action, such as using printing tape, can better improve the product image. The above is a sharing of the details you need to pay attention to when installing tape using an automatic box sealer. I hope it will be helpful to everyone.