Do you know what are the common faults of carton sealing machines

Carton sealing machine is suitable for the sealing form of tape. As long as the sealing method is sealed in this way, the work can be completed. Since the technical requirements for this kind of sealing machine are not high, the product price is not very high compared to other packaging machines, and it is economical and practical. Since the box sealer is simple to operate, some failures often occur due to improper operation. Below are some common faults and solutions for automatic box sealer manufacturers introduced by the editor of box sealer manufacturer to provide some emergency solutions to box sealer operators.

The clamping nail formation of the box sealing machine is insufficient or the movement is too slow.

Reason: The inner piece is worn, the screws are loose, or the position of the front buckle shaft is staggered.

Fault solution: Replace the inner piece of the trigger or slightly adjust the front buckle shaft up or slightly adjust the front buckle shaft down, and then try to run the machine separately. The easy air leakage around the piston rod is mainly due to the consumption and wear of the bottom ring of the main body due to long-term operation, so the bottom ring should be replaced in time. Air leakage is prone to air at the trigger, which may be caused by damage to the switch valve ring or the switch seat ring, and should also be replaced in time. In addition, there are exhaust ports that are prone to air leakage, which may be damaged by the piston ring. Please replace them in time.

Cause: It may be that the plastic steel bar or the transmission spring is not elastic.

Solution: Remove the trigger combination first, reinstall the spring tip or replace a new plastic steel bar and transmission spring