What are the instructions and precautions for fully automatic unpacking machine?

What are the spare parts for fully automatic unpacking machines? What aspects should be paid attention to during use? As an increasingly automated packaging device on the market, the fully automatic unboxing machine will have some minor problems after users use it for a certain period of time, and the reasons for the minor problems are mostly because of the need to replace consumable parts. So for fully automatic unboxing machines, what spare parts do users need to prepare? Below, the editor of the unpacking machine manufacturer will introduce to you three common consumable parts and precautions for use.

Frequent spare parts for fully automatic unboxing machines:

1. Knife holder spring: Familiar users know its function, which is to help the cutter perform swinging operations back and forth. The cutter works once, and the corresponding spring works once. Therefore, the knife holder spring is one of the vulnerable accessories of the box sealing machine, and there is no doubt that it is.

2. Transport belt: The main job of the conveyor belt is to clamp the carton and transport it forward. Over time, the patterns on the belt will be flattened, which will weaken the friction of the belt and slippage will occur during the work process. At this time, the belt needs to be replaced.

3. Cutting knife: There is no doubt that the cutter is a necessary part in the sealing process, and its function cannot be ignored. However, after a long time of use, the cutter will become dull and will not be sharp, so it needs to be replaced.

Precautions for using the fully automatic unboxing machine:

1. Check whether there is any debris in the unboxing mechanism. If there is any need to be cleaned, blow the dust in the rail groove with air pressure.

2. Check whether the local lubrication is in place. If not, the crankshaft must be refueled by dipping the oil. Usually, a small stick is dipped in oil and gradually dripping it on the shaft.

3. Check whether the screws on the unboxing mechanism are loose, and whether the screws and nuts of each component can be loosened. It should be tightened in time.

4. When the computer is turned on, an abnormality or alarm occurs. Please check the alarm prompt in time and handle the problem according to the prompts. If abnormal scenes are found during the boot process, such as loud noise, vibration, and odor, if you cannot find it yourself, you should stop calling the repair personnel to deal with it to prevent damage to external parts.