A brief analysis of the reason why the packaging machine is always broken

Whether the baler is easy to use is very closely related to the packing belt. The baler always has a broken belt. Customers will think that the quality of the baler is not good, but in fact, this is not the case. The following editor of the baler manufacturer will briefly analyze the reason why the baler always has a broken belt.

1. The packaging belt is too inferior.

2. Use semi-automatic packaging tape. The reason why many customers buy automatic vanishers is because the semi-automatic efficiency is too low and labor is wasted, so they buy automatic vanishers. However, the packaging tapes used in the semi-automatic vanishers were reluctant to throw away and were directly used on the automatic vanishers. This is not possible. The automatic vanisher must use a fully automatic vanishing belt, also known as a brand new material vanishing belt. Since there is less new material, the semi-automatic vanishing belt will not be glued.

3. The tightening force is too large. Although the tightening force of the baler is adjustable, it is not recommended that you adjust it too much. The impact of the tightening force is that the rebound force is too large after the bundling is completed, causing the belt to collapse. If you must need such a large tightening force, you should adjust the cooling time at the same time to increase the time for the bonding of the packaging belt.

4. The perm position is inaccurate. Under normal circumstances, the perm should be between two layers of packaging tapes. However, due to the influence of transportation or heavy objects pressure, the position of the perm will sometimes be inaccurate and may be deflected. In this case, the packaging tape will also collapse.

5. The perming temperature is too high, causing the packaging belt to be broken.

6. The front or back knife is too sharp and the position of the upper slide cover is inconsistent, and it will be cut off during packaging.

7. The perming temperature is too low and it is not sticky at all. The most common one is that the temperature is too high or too low, and it needs to be adjusted.