How to maintain the belt of the box sealer

The belt of the box sealer is one of the vulnerable accessories of the box sealer. Although it is not as easy to wear like a cutter, if used improperly, it will still cause its service life to be short. So how should the belt of the box sealer be maintained? Below, the editor of the box sealer manufacturer briefly introduces a few points.

1. Before using the fully automatic box sealer, be sure to lubricate it;

2. Before lubrication, do not connect the air pressure source to flip the fully automatic box sealer, so that the air inlet is facing upward, drip from the air inlet, and adjust the height of the workbench. This can adjust the height of the table according to your comfort level, and then tighten the screws on the tripod;

3. Drop lubricant, do not use detergent or additives as lubricant. After refueling, please briefly empty the bottom of the fully automatic box sealer. After adjusting the height, put the length of the fully automatic box sealer is about one-third of the length of the box. You can move the vertical lift rack according to the size of the box and adjust the movement height to know that the upper and lower movements just touch the box;

4. Wipe the oil that is exhausted from the exhaust port. The excess oil will damage the ring in the fully automatic box sealer. If the air in the air inlet has lubricant, you do not need to refuel every day;

5. Adjust the conveyor belt of the fully automatic box sealing machine to tighten the box, shake the handle, and after adjustment, ensure that the machine can operate continuously. The fully automatic system and connection are an important process, which will increase the efficiency and life of the fully automatic box sealing machine.

6. Avoid using it in environments where strong acids and strong alkalis are already highly corrosive. The belt of the box sealer is actually a high-strength rubber. If used in such an environment, it will easily be corroded and its service life will naturally shorten.

7. Try to avoid transporting heavier items. The drive belt of the box sealer is transmitted by friction between the patterns on the belt and the items. If the items conveyed by the user are heavy, the wear on the belt will be severe. After a long time of use, the service life of the belt will be shortened.

8. Avoid sunlight. The sunlight will cause the belt of the sealer to weather severely, and the belt needs to be replaced over time.

In addition, when the box sealer is running, the box belt clamps the sides of the carton and moves forward. The front short tongue is automatically bent through the tongue pressing frame, and the back short tongue is when the carton enters the fully automatic box sealing machine roller, a detection signal (optoelectronic signal) notifies the tongue pressing cylinder to act, and the tongue pressing frame bends it, and a signal is notified that the melting glue machine automatically spray glue.